2004 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Scan Tool Output Controls

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls

Scan Tool Output Control Additional Menu Selection(s) Description
Inadvertent Power Inadvertent Power Reports Inadvertent power status and commands On/Off for 5 seconds
Load Management Miscellaneous Test Activates load shed sequence to test equipment responses
Retained Accessory Power Miscellaneous Test Commands RAP relay On/Off for 5 seconds to check equipment responses
Power Moding Power Moding Displays power mode as transmitted on class 2 serial data circuits
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.