2004 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

ABS Component Views

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Hubs and Rotors Component View
GM826162Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 LH Steering Knuckle
2 Wheel Speed Sensor - LF
3 Wheel Speed Sensor - RF
4 RH Steering Knuckle
Fig 2: I/P Trim Panel Component View
GM754541Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Traction Control Switch - Chevrolet
2 Traction Control Switch - GMC
3 Traction Control Switch - Buick/Oldsmobile
Fig 3: Electronic Brake Control Module (EBCM) Component View
GM599037Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Electronic Brake Control Module (EBCM)
2 Electronic Brake Control Module (EBCM) Electrical Connector - C1
3 Electronic Brake Control Module (EBCM) Electrical Connector - C2
4 Frame
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.