Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004AZTEK AWD V6-3.4L VIN EREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER HEAD ASSEMBLYSYSTEM SPECIFICATIONSTORQUE SPECIFICATIONS
2004 Pontiac Aztek AWD V6-3.4L VIN E
Torque Specifications
2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Torque Specifications
TORQUE SPECIFICATIONS
LEFT
RIGHT
Cylinder Head Bolt
First Pass 60 Nm (44 ft. lbs.)
Final Pass 95 degrees
Bolt Re-usabillity Always new
Lower Intake Manifold Bolt - Center
First Pass 7 Nm (62 inch lbs.)
Final Pass 13 Nm ( 115 inch lbs.)
Lower intake Manifold Bolt - Corner
First Pass 13 Nm (115 inch lbs.)
Final Pass 25 Nm (18 ft. lbs.)
Camshaft Sprocket Bolt 140 Nm (103 ft. lbs.)
Exhaust Manifold
Heat Shield Bolt 10 Nm (89 inch lbs.)
Nut 16 Nm (12 ft. lbs.)
Stud 18 Nm (13 ft. lbs.)
LEFT
RIGHT
Cylinder Head Bolt
First Pass 60 Nm (44 ft. lbs.)
Final Pass 95 degrees
Bolt Re-usabillity Always new
Lower Intake Manifold Bolt - Center
First Pass 7 Nm (62 inch lbs.)
Final Pass 13 Nm ( 115 inch lbs.)
Lower intake Manifold Bolt - Corner
First Pass 13 Nm (115 inch lbs.)
Final Pass 25 Nm (18 ft. lbs.)
Camshaft Sprocket Bolt 140 Nm (103 ft. lbs.)
Exhaust Manifold
Heat Shield Bolt 10 Nm (89 inch lbs.)
Nut 16 Nm (12 ft. lbs.)
Stud 18 Nm (13 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.