Cruise Control Module: Service and Repair

2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Service and Repair
CRUISE CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Remove the cruise control cable from the module.
2. Disconnect the electrical connector from the cruise control module.




3. Remove the cruise control module from the bracket.

INSTALLATION PROCEDURE




1. Install the cruise control module to the bracket.
2. Connect the electrical connector to the cruise control module.
3. Install the cruise control cable to the module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.