2003 Pontiac Vibe Base, AWDFACTORY OEM SERVICE PROCEDURE

Test Description

The numbers below refer to the step numbers on the diagnostic procedures.

  1. 1

    The Diagnostic System Check - Engine Controls prompts the technician to complete some basic checks and store the freeze frame data on the scan tool, if applicable. This creates an electronic copy of the data taken when the fault occurred. The information is then stored in the scan tool for later reference.
  2. 2

    This step checks for fuel injector control signals from the PCM.
  3. 3

    This step checks for a fault that affects all the fuel injectors.
  4. 5

    This step checks for a short in the fuel injector control circuit.
  5. 8

    This step checks for ignition positive voltage.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.