Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE
General Engine Specifications
Fastener Tightening Specifications


General


Overhaul
Engine Mechanical Specifications

General



Overhaul
Tightening Sequence

Cylinder Head
Refer to the procedure Service and Repair
Camshaft Bearing Caps
Refer to the procedure Service and Repair

Exhaust Manifold
Thread Repair Specifications



Engine Block-Front View


Engine Block-Back View


Engine Block-Left Side View



Engine Block-Bottom View



Engine Block-Right Side View



Engine Block-Top View


Lower Crankcase - Front View


Lower Crankcase-Back View


Lower Crankcase - Bottom View


Lower Crankcase - Left View


Lower Crankcase-Right View



Cylinder Head-Top View


Cylinder Head-Intake Manifold Deck View


Cylinder Head-Exhaust Manifold Deck View


Cylinder Head-Front View


Cylinder Head-Back View
Note: 1, 2, 5, 6 holes are oil passages.


Cylinder Head-Bottom View
General
Overhaul
Engine Mechanical Specifications
General
Overhaul
Tightening Sequence
Cylinder Head
Refer to the procedure Service and Repair
Camshaft Bearing Caps
Refer to the procedure Service and Repair
Exhaust Manifold
Thread Repair Specifications
Engine Block-Front View
Engine Block-Back View
Engine Block-Left Side View
Engine Block-Bottom View
Engine Block-Right Side View
Engine Block-Top View
Lower Crankcase - Front View
Lower Crankcase-Back View
Lower Crankcase - Bottom View
Lower Crankcase - Left View
Lower Crankcase-Right View
Cylinder Head-Top View
Cylinder Head-Intake Manifold Deck View
Cylinder Head-Exhaust Manifold Deck View
Cylinder Head-Front View
Cylinder Head-Back View
Note: 1, 2, 5, 6 holes are oil passages.
Cylinder Head-Bottom View
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
