2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE

Connecting Rod, Engine

Rod Bearing Bore I.D. 52.118-52.134 mm (2.0519-2.0525 inch)
Rod Bearing Shell Thickness 1.539-1.545 mm (0.0606-0.608 inch)
Rod Bearing I.D., 90 degree 49.043-49.073 mm (1.9308-1.9320 inch)
Rod Bearing I.D., 45 degree With-in +0.009/-0.004 of 90 degree spec.
Rod Bearing to Crankpin Clearance 0.029-0.069 mm (0.0011-0.0027 inch)
Rod Small End I.D. 20.007-20.021 mm
Rod Side Clearance 0.070-0.370 mm (0.0028-0.0146 inch)
Rod Twist 0.040 max.
Rod Bend 0.021 max.
Rod Large End Micro 2.0 Ra max.
Rod Small End Micro 0.3 Ra max.
Piston Pin Endplay 0.19-1.16 mm (0.007 5-0.0461 inch)
Connecting Rod Bolt
First Pass 18 ft.lbs.
Final Pass 100°
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.