Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE
Body Control Module: Service and Repair
BODY CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Release the body control module (BCM) wire harness retainer from the BCM bracket.
3. Disconnect the BCM electrical connectors from the BCM.
4. Release the lock tabs and remove the BCM from the BCM bracket.

5. Remove the BCM bracket nuts (2) if required.
6. Remove the BCM bracket (1) as an assembly if required.
INSTALLATION PROCEDURE

1. Install the BCM bracket (1) as an assembly if required.
2. Install the BCM bracket nuts (2) if required.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 5 N.m (44 lb in).

3. Install the BCM into the BCM bracket until lock tabs are fully seated.
4. Connect the BCM electrical connectors to the BCM.
5. Install the BCM wire harness retainer to the BCM bracket.
6. Connect the negative battery cable.
7. Reprogram the BCM. Programming and Relearning
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Release the body control module (BCM) wire harness retainer from the BCM bracket.
3. Disconnect the BCM electrical connectors from the BCM.
4. Release the lock tabs and remove the BCM from the BCM bracket.
5. Remove the BCM bracket nuts (2) if required.
6. Remove the BCM bracket (1) as an assembly if required.
INSTALLATION PROCEDURE
1. Install the BCM bracket (1) as an assembly if required.
2. Install the BCM bracket nuts (2) if required.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 5 N.m (44 lb in).
3. Install the BCM into the BCM bracket until lock tabs are fully seated.
4. Connect the BCM electrical connectors to the BCM.
5. Install the BCM wire harness retainer to the BCM bracket.
6. Connect the negative battery cable.
7. Reprogram the BCM. Programming and Relearning
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
