2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE

Body Control Module: Service and Repair

BODY CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

Factory service manual diagram



2. Release the body control module (BCM) wire harness retainer from the BCM bracket.
3. Disconnect the BCM electrical connectors from the BCM.
4. Release the lock tabs and remove the BCM from the BCM bracket.

Factory service manual diagram



5. Remove the BCM bracket nuts (2) if required.
6. Remove the BCM bracket (1) as an assembly if required.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the BCM bracket (1) as an assembly if required.
2. Install the BCM bracket nuts (2) if required.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the nuts to 5 N.m (44 lb in).

Factory service manual diagram



3. Install the BCM into the BCM bracket until lock tabs are fully seated.
4. Connect the BCM electrical connectors to the BCM.
5. Install the BCM wire harness retainer to the BCM bracket.
6. Connect the negative battery cable.
7. Reprogram the BCM. Programming and Relearning
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.