Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE
Ignition Control Module: Description and Operation
IGNITION CONTROL MODULE (ICM) AND IGNITION COILS

1. Ignition Control Module (ICM)
2. Compression Sense Ignition (CSI) Pickup
3. Not Used
4. 2-3 Coil Control
5. Ignition Voltage
6. 1-4 Coil Control
7. Not Used
8. Interconnect
Each ignition coil is responsible for supplying secondary energy to a pair of spark plugs. The ignition control signals output by the PCM are amplified by the ICM in order to fire each coil. The spark events are triggered by the ICM, but the module has no influence on spark timing. The ICM is also responsible for detecting and supplying a camshaft position (CMP) signal pulse to the PCM to be used for sequential fuel injection. This ignition system does not use a conventional CMP sensor that detects valve train position. The ICM detects when either cylinder 1 or cylinder 3 has fired on the cylinders compression stroke using sensing circuitry integrated within each coil. The sensing circuit detects the polarity and the strength of the secondary voltage output, the higher output is always at the event cylinder. The ICM sends a CMP signal to the PCM based on the voltage difference between the event and waste cylinder firing energy.
This system is called compression sense ignition. By monitoring the camshaft position and crankshaft position (CKP) signals the PCM can accurately time the operation of the fuel injectors.
1. Ignition Control Module (ICM)
2. Compression Sense Ignition (CSI) Pickup
3. Not Used
4. 2-3 Coil Control
5. Ignition Voltage
6. 1-4 Coil Control
7. Not Used
8. Interconnect
Each ignition coil is responsible for supplying secondary energy to a pair of spark plugs. The ignition control signals output by the PCM are amplified by the ICM in order to fire each coil. The spark events are triggered by the ICM, but the module has no influence on spark timing. The ICM is also responsible for detecting and supplying a camshaft position (CMP) signal pulse to the PCM to be used for sequential fuel injection. This ignition system does not use a conventional CMP sensor that detects valve train position. The ICM detects when either cylinder 1 or cylinder 3 has fired on the cylinders compression stroke using sensing circuitry integrated within each coil. The sensing circuit detects the polarity and the strength of the secondary voltage output, the higher output is always at the event cylinder. The ICM sends a CMP signal to the PCM based on the voltage difference between the event and waste cylinder firing energy.
This system is called compression sense ignition. By monitoring the camshaft position and crankshaft position (CKP) signals the PCM can accurately time the operation of the fuel injectors.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
