2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE

Transmission Position Sensor/Switch: Service and Repair

PNP Switch Replacement

Removal Procedure
1. Remove the shift linkage.
2. Disconnect the electrical connector.

Factory service manual diagram




3. Remove the park/neutral position switch mounting bolts.

Factory service manual diagram




4. Remove the park/neutral position switch assembly.

Installation Procedure
Using Old Switch
1. Place the shift shaft in N (Neutral).
2. Align the flats of the shift shaft with the switch.

Notice: Refer to Fastener Notice in Service Precautions.

Factory service manual diagram




3. Install the park/neutral position switch mounting bolts.
Tighten the bolts to 24 Nm (18 ft. lbs.).

Important: Ensure that the engine will only start in the P (Park) or the N (Neutral) position. Readjust the switch if the engine will start in any other position.

4. Turn the ignition switch to the ON position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.