Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE
HVAC Control Assembly Replacement
HVAC CONTROL ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE

1. Remove the I/P trim plate.
2. Remove the HVAC control assembly retaining screws.
3. Pull the HVAC control assembly (1) away from the I/P.
4. Disconnect the electrical connections.
5. Disconnect the mode control cable.
6. Disconnect the temperature control cable.
INSTALLATION PROCEDURE

1. Connect the electrical connections.
2. Connect the mode control cable.
3. Connect the temperature control cable.
4. Install the HVAC control assembly (1) to the I/P.
5. Install the HVAC control assembly retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screw to 2 N.m (18 lb in).
6. Install the I/P trim plate.
REMOVAL PROCEDURE
1. Remove the I/P trim plate.
2. Remove the HVAC control assembly retaining screws.
3. Pull the HVAC control assembly (1) away from the I/P.
4. Disconnect the electrical connections.
5. Disconnect the mode control cable.
6. Disconnect the temperature control cable.
INSTALLATION PROCEDURE
1. Connect the electrical connections.
2. Connect the mode control cable.
3. Connect the temperature control cable.
4. Install the HVAC control assembly (1) to the I/P.
5. Install the HVAC control assembly retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screw to 2 N.m (18 lb in).
6. Install the I/P trim plate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
