2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE

Compressor Replacement

TOOLS REQUIRED
J 39400-A Halogen Leak Detector

REMOVAL PROCEDURE

Factory service manual diagram



1. Recover the refrigerant.
2. Release the drive belt tensioner.
3. Remove the drive belt from the A/C compressor.
4. Raise the vehicle. Refer to Vehicle Lifting.
5. Remove the right front fender liner.
6. Disconnect the electrical connector from the compressor.

Factory service manual diagram



7. Remove the compressor hose assembly bolt from the compressor.
8. Remove the compressor hose assembly from the compressor.
9. Remove and discard the sealing washers.

Factory service manual diagram



10. Remove the compressor mounting bolts.
11. Remove the compressor.
12. If replacing the compressor Refer to Compressor Oil Balancing.

IMPORTANT: NEW CVC compressor assemblies are shipped with a full poly-alkylene glycol (PAG) refrigerant oil charge. Use of the incorrect PAG oil can result in compressor failure.

INSTALLATION PROCEDURE
1. The CVC compressor uses a low viscosity refrigerant oil, GM P/N 12378526 (Canadian P/N 88900060).

NOTE: Do not mix refrigerant oils. Use of incorrect refrigerant oil will cause compressor failure.

Factory service manual diagram



2. Install the bolts and the compressor to the engine.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the top compressor bolts to 22 N.m (16 lb ft).

Factory service manual diagram



3. Install new sealing washers on the compressor ports.
4. Install the A/C compressor hose assembly to the compressor.
5. Install the A/C compressor hose assembly bolt.

Tighten
Tighten the bolt to 11 N.m (8 lb ft).

Factory service manual diagram



6. Connect the compressor electrical connector.
7. Lower the vehicle.
8. Install the drive belt on the A/C compressor
9. Release the drive belt tensioner.
10. Evacuate and charge the refrigerant system.
11. Leak test the fittings of the repaired or reinstalled component using the J 39400-A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.