2003 Pontiac Sunfire L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE

Cruise Control Module: Service and Repair

CRUISE CONTROL MODULE REPLACEMENT (2.2L L61)

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

Factory service manual diagram



2. Disconnect the electrical connector (1) from the cruise control module.

Factory service manual diagram



3. Open the throttle body cam slightly.
4. Disconnect the cruise control cable from the throttle body cam lever.
5. Remove the cruise control cable from the throttle body bracket.
6. Remove the cruise control cable from the retainer clip on the engine.

Factory service manual diagram



7. Disconnect the cruise control cable from the cruise control module by turning the cable 1/4 turn counterclockwise.

Factory service manual diagram



8. Disconnect the cruise control cable slug from the ribbon buckle.

Factory service manual diagram



9. Remove the bolts (1) from the cruise control module.

Factory service manual diagram



10. Remove the bolt and nut (1) from the cruise control module mounting bracket.
11. Remove the cruise control module from the engine compartment.

INSTALLATION PROCEDURE
1. Position the cruise control module to the mounting bracket.

Factory service manual diagram



2. Install the bolts (1) to the cruise control module.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolts to the cruise control module to 10 N.m (89 lb in).

Factory service manual diagram



3. Position the cruise control module to the engine compartment.
4. Install the bolt and nut (1) to the cruise control module mounting bracket.

Tighten
Tighten the nuts to the cruise control module to 10 N.m (89 lb in).

Factory service manual diagram



5. Connect the cruise control cable slug to the ribbon buckle.

IMPORTANT: The ribbon must not be twisted.

Factory service manual diagram



6. Insert the cruise control cable into the cruise control module until the seal touches the module.
7. Position the narrow cable tab into the narrow slot and the wide tab into the wide slot.
8. Connect the cruise control cable to the cruise control module by turning the cable clockwise.

IMPORTANT: The adjuster tab must be pointing toward the front of the car after installation.

Factory service manual diagram



9. Connect the electrical connector to the cruise control module.

Factory service manual diagram



10. Install the cruise control cable to the throttle body bracket pressing into place until fully seated.
11. Open the throttle body cam slightly.
12. Connect the cruise control cable to the throttle body cam lever.
13. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.