Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Software Upgrade - OBD System Improvements (Reprogram Pcm) (03064)
Reference number: 03064
SYSTEM SOFTWARE UPGRADE - OBD SYSTEM IMPROVEMENTS (REPROGRAM PCM)
SERVICE CAMPAIGN BULLETIN
| CHEVROLET: | 2002-2003 Caviler (built before 37376322 or 3S207455) with 2.2L Engine (VIN F - RPO L61) |
| OLDSMOBILE: | 2002-2003 Alero with 2.2L Engine (VIN F - RPO L61) |
| PONTIAC: | 2002-2003 Sunfire (built before 37376320 or 3S207453); 2002-2003 Pontiac Grand Am with 2.2L Engine (VIN F - RPO L61) |
| SECTION: | 06 - |
PURPOSE
This bulletin provides information about installing new Powertrain Control Module (PCM) software and calibration on certain 2002-2003 vehicles equipped with 2.2L 4 cylinder engines. The revised calibration includes several OBD system improvements that should be installed as soon as practical. Install the new calibration on all affected vehicles identified in this bulletin, including vehicles in new dealer inventory and any vehicles that return for service, for any reason, during the applicable 8 year 80,000 mile (130,000 km) emission warranty coverage period. To verify if an updated calibration is required, refer to the following procedure in this bulletin.
SERVICE PROCEDURE
Using a Tech 2 scan tool and TIS 2000, verify whether the calibration programmed into the vehicle's PCM has been programmed since the calibration listed below or later. The GM Vehicle Inquiry System (GM VIS) may be checked to see if the vehicle has been programmed since the below calibration or the labor operation Y0002 has been claimed on the vehicle. If the below or later updated calibration has not been installed or the Y0002 labor operation has not been claimed, reprogram the ECM with the latest updated calibration from TIS 2000 version 6.5 for 2003 data update or later.
| Model Year | Vehicle | Transmission | Emissions Type | Calibration P/N |
|---|---|---|---|---|
| 2002 | Cavalier/Sunfire | Manual | Nationwide | 12583766 |
| " | " | Automatic | Nationwide | 12583768 |
| " | Grand Am/Alero | Manual | Nationwide | 12583772 |
| " | " | Automatic | Nationwide | 12583770 |
| 2003 | Cavalier/Sunfire | Manual | Nationwide | 12583740 |
| " | " | Automatic | Nationwide | 12583742 |
| " | " | " | California LEV - Natural Gas | 12583744 |
| " | Grand Am/Alero | Manual | Nationwide | 12583747 |
| " | " | Automatic | Nationwide | 12583745 |
WARRANTY INFORMATION
For vehicles repaired under the 8 year or 80,000 mile(130,000 km) emission warranty use:
| Labor Op. | Description | Labor Time |
|---|---|---|
| Y0002 | Powertrain Control Module - Reprogram | 0.4 hr |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
