2003 Pontiac Sunfire AutomaticFACTORY OEM SERVICE PROCEDURE

Spark Plug Visual Inspection

  1. Normal Operation  - Brown to Grayish-Tan with small amounts of White powdery deposits are normal combustion by-products from fuels with additives.
  2. Carbon Fouled  - Dry, fluffy Black carbon, or soot caused by rich fuel mixtures, leaking fuel injectors, excessive fuel pressure, restricted air filter element or incorrect combustion. Reduced ignition system voltage output, weak coils worn ignition wires or incorrect spark plug gap. Excessive idling or slow speeds under light loads can keep spark plug temperatures so low that normal combustion deposits may not burn off.
  3. Deposit Fouling  - Oil, coolant, or additives that include substances such as silicone, very white coating, reduces the spark intensity. Most powdery deposits will not effect spark intensity unless they form into a glazing over the electrode.
Fig 1: Identifying Spark Plug Components
G00196156Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.