Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Sunfire AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the three way catalytic converter seals. See Figure.
- Install the intermediate pipe to the hanger.
- Install the intermediate pipe bolts to catalytic converter. See Figure.
Tighten
Tighten the intermediate pipe bolts to 30 N.m (22 ft lbs).
- Clamp the muffler (2) to the intermediate pipe (1).
- Lower the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
