2003 Pontiac Sunfire AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

CONNECTORS LOCATION

Component Location
C001 (Black, 10 Pin) At left front of engine compartment. See Figure .
C002 (Black, 6 Pin) At left rear of engine compartment, under brake master cylinder.
C003 (Black, 3 Pin) Behind left side of dash. See Figure .
C004 (Black, 6 Pin) Rear of vehicle near CNG tank. See Figure .
C005 (Black, 1 Pin) Rear of vehicle, near CNG tank. See Figure .
C100 (Black, 38 Pin) At left side of engine compartment.
C101 (Black, 15 Pin) At left front of engine compartment.
C102 (Black, 8 Pin) Near throttle body.
C103 (Gray, 14 Pin) On automatic transmission.
C104 (Gray, 2 Pin) On left rear center of engine, near crankshaft position sensor.
C200 (Black, 23 Pin) Behind left end of dash.
C201 (Black, 3 Pin) Near right "B" pillar.
C202 (Black, 6 Pin) Behind left end of dash.
C203 (Black, 3 Pin) Behind left side of dash.
C204 (Black, 8 Pin) Behind right side of dash.
C206 (Yellow, 2 Pin) At lower dash tie bar.
C207 (Yellow, 2 Pin) At lower dash tie bar.
C220 (Light Green, 6 Pin) Behind left end of dash.
C221 (Yellow, 8 Pin) Behind left end of dash.
C222 (10 Pin) Behind right end of dash.
C313 (Light Gray, 16 Pin) Under center of rear seat.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.