2003 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE

Engine Mount

Engine Mount Strut and A/C Compressor Bracket Bolt 37 ft. lbs.
Engine Mount Strut and Lift Bracket Bolt - Engine Lift Rear 52 ft. lbs.
Engine Mount Strut and Generator Bracket Bolt 37 ft. lbs.
Engine Mount Strut and Support Bracket Large Bolt 41 ft. lbs.
Medium Bolt 41 ft. lbs.
Small Bolt 20 ft. lbs.
Engine mount bracket to engine block bolt (AWD Only) 63 ft.lbs.
Engine mount bracket to oil pan bolt 43 ft.lbs.
Engine mount lower nut 35 ft.lbs.
Engine mount strut bolt 35 ft.lbs.
Engine mount strut bracket bolt Left 52 ft.lbs.
Right 37 ft.lbs.
Engine mount strut bracket bolt to radiator support, upper 19 ft.lbs.
Engine mount strut nut 35 ft.lbs.
Engine mount upper nut 39 ft.lbs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.