2003 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE

Scan Tool Data List

Transmission Scan Tool Data List

Transmission Scan Tool Data List Part 1 Of 3:

Factory service manual diagram



Transmission Scan Tool Data List Part 2 Of 3:

Factory service manual diagram



Transmission Scan Tool Data List Part 3 Of 3:

Factory service manual diagram




Use the scan tool data list under the following conditions:
^ The Diagnostic System Check is complete.
^ The on-board diagnostics are functioning properly.
^ No DTCs are present. The values below represent a typical display recorded from a properly functioning system.

Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts. Only the parameters listed below are used for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.

Scan tool values below were recorded under the following conditions:
^ Engine at Idle
^ Upper radiator hose hot
^ Closed throttle
^ Transmission in PARK
^ Closed Loop operation
^ Accessories OFF
^ Brake pedal not applied
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.