2003 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE

Ignition Control Module: Service and Repair

REMOVAL PROCEDURE

Factory service manual diagram



1. Disconnect all the electrical connectors at the ignition control module (ICM).
2. Note the position of the spark plug wires for installation and disconnect the spark plug wires from the ignition coils.
3. Remove the screws securing the coil assemblies to the ignition control module.
4. Disconnect the coils from the ignition control module.
5. Remove the fasteners securing the ignition control module assembly to the engine.
6. Remove the ignition control module from the bracket.

INSTALLATION PROCEDURE
1. Install the ignition control module on the bracket.

Factory service manual diagram



2. Install the coils to the ignition control module.
3. Reinstall the fasteners securing the ignition control module assembly to the engine.
4. Reinstall the screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 4.5 N.m (40 lb in).

5. Connect the spark plug wires as noted during removal.
6. Connect the electrical connectors to the ignition control module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.