Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Vehicle Speed Sensor: Service and Repair
Vehicle Speed Sensor (VSS) Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector at the vehicle speed sensor.

3. Remove the retaining bolt (9) and the sensor (10).
Installation Procedure

1. Inspect the O-ring (11). If damaged, replace as necessary.
Notice: Refer to Fastener Notice in Service Precautions.

2. Install the vehicle speed sensor (10) and the retaining bolt (9).
Tighten the bolt to 12 Nm (106 inch lbs.).
3. Connect the electrical connector to the sensor.
4. Lower the vehicle.
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector at the vehicle speed sensor.
3. Remove the retaining bolt (9) and the sensor (10).
Installation Procedure
1. Inspect the O-ring (11). If damaged, replace as necessary.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the vehicle speed sensor (10) and the retaining bolt (9).
Tighten the bolt to 12 Nm (106 inch lbs.).
3. Connect the electrical connector to the sensor.
4. Lower the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
