Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Keyless Entry Receiver: Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the upper trim pad.

2. Disconnect the remote control door lock receiver electrical connector (1).
3. Remove the remote control door lock receiver (2) from the defroster air duct.
IMPORTANT: Disengage the remote control door lock receiver retainers and lift upward.
INSTALLATION PROCEDURE

1. Install the remote control door lock receiver (2).
IMPORTANT: Position the remote control door lock receiver to the defroster air duct.
2. Engage the remote control door lock receiver retainers.
3. Connect the remote control door lock receiver electrical connector (1).
4. Install the upper trim pad.
5. If a new remote control door lock receiver is being installed, program the transmitter. Programming and Relearning
REMOVAL PROCEDURE
1. Remove the upper trim pad.
2. Disconnect the remote control door lock receiver electrical connector (1).
3. Remove the remote control door lock receiver (2) from the defroster air duct.
IMPORTANT: Disengage the remote control door lock receiver retainers and lift upward.
INSTALLATION PROCEDURE
1. Install the remote control door lock receiver (2).
IMPORTANT: Position the remote control door lock receiver to the defroster air duct.
2. Engage the remote control door lock receiver retainers.
3. Connect the remote control door lock receiver electrical connector (1).
4. Install the upper trim pad.
5. If a new remote control door lock receiver is being installed, program the transmitter. Programming and Relearning
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
