2003 Pontiac Aztek FWDFACTORY OEM SERVICE PROCEDURE

Conditions For Running DTC

  • Engine run time is 120-440 seconds.
  • DTCs P0112, P0113, P0116, P0117, or P0118 not set.
  • The minimum Intake Air Temperature (IAT) is 19°F (-7°C) or more.
  • The start-up coolant temperature is -40 to 104°F (-40 to 40°C).
  • Accumulated Mass Airflow (MAF) is 1252-5670 grams.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.