2003 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE

Conditions For Running DTC

  • No MAP sensor DTC P0107 or P0108.
  • No TP sensor DTC P0121, P0122 or P0123.
  • No AT ISS DTC P0716 or P0717.
  • The TP angle is greater than 12 percent.
  • Engine torque is 70-300 ft. lbs. (95-400 N.m).
  • Input shaft speed is 1500 RPM or greater.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.