Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Connect the electrical connectors.
Push in on the switch bank in order to install the switch bank.

Fig 1: Connecting Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Install the bolts/screws to the switch bank to instrument panel.
Tighten

Tighten the bolts/screws to 2.5 N.m (22 lb in).

Fig 2: Installing Switch Bank
Courtesy of GENERAL MOTORS CORP.
Install the instrument panel accessory trim plate.

Fig 3: Locating Traction Control Switch

Courtesy of GENERAL MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.