Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Firebird Formula, AutomaticFACTORY OEM SERVICE PROCEDURE
Test Description
The numbers below refer to the step numbers in the diagnostic procedures.
- 3
This step tests the MAP sensor's ability to correctly indicate barometric pressure. The value shown for the MAP sensor varies with altitude. 103 kPa is the approximate Barometric (BARO) pressure displayed at or near sea level. - 5
This step tests the MAP sensor's ability to respond to an increase in engine vacuum. - 6
This step tests for a proper MAP sensor kPa with an applied vacuum.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
