Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Wiper Control Module: Service and Repair
WIPER MOTOR MODULE REPLACEMENT
REMOVAL PROCEDURE

1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the underhood electrical center.
4. Remove the cruise control module.
5. Disconnect the wiper motor cover electrical connector.
6. Remove the wiper system drive module bolts.
7. Remove the wiper system drive module from the engine compartment.
INSTALLATION PROCEDURE

1. Position the wiper system drive module to the cowl.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the wiper system drive module bolts.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
3. Connect the wiper motor cover electrical connector.
4. Install the cruise control module and bracket.
5. Install the underhood electrical center.
6. Install the air inlet grille panel.
7. Install the wiper arms.
REMOVAL PROCEDURE
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the underhood electrical center.
4. Remove the cruise control module.
5. Disconnect the wiper motor cover electrical connector.
6. Remove the wiper system drive module bolts.
7. Remove the wiper system drive module from the engine compartment.
INSTALLATION PROCEDURE
1. Position the wiper system drive module to the cowl.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the wiper system drive module bolts.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
3. Connect the wiper motor cover electrical connector.
4. Install the cruise control module and bracket.
5. Install the underhood electrical center.
6. Install the air inlet grille panel.
7. Install the wiper arms.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
