Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
| Connecting Rod Bearing Cap Nut | First Pass | 15 ft. lbs. |
| Final Pass | 75° | |
| Connecting Rod | Bearing Journal Diameter | 1.9987 - 1.9994 inch |
| Rod Bearing Journal Taper- Max | 0.0002 inch | |
| Rod Bearing Journal Out Of Round - Max | 0.0002 inch | |
| Rod Bearing Bore Diameter | 2.124 - 2.125 inch | |
| Rod Inside Bearing Diameter | 2.000 - 2.002 inch | |
| Rod Bearing Journal Clearance | 0.0007 - 0.0024 inch | |
| Rod Side Clearance | 0.007 - 0.017 inch |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
