Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
FRONT SUSPENSION
Camber -0.63° ± 0.50°
Camber Cross Tolerance 0.00° ± 0.75°
Caster 2.41° ± 0.50°
Caster Cross Tolerance 0.00° ± 0.75°
Total Toe 0.00° ± 0.20°
Steering Wheel Angle 0.00° ± 3.50°
Thrust Angle ------
REAR FRONT WHEEL DRIVE (FWD) TWIST AXLE
Camber -0.00° ± 0.40°
Camber Cross Tolerance ------
Caster ------
Caster Cross Tolerance ------
Total Toe 0.00° ± 0.30°
Steering Wheel Angle ------
Thrust Angle 0.00° ± 0.15°
REAR ALL WHEEL DRIVE (AWD)
Camber -0.25° ± 0.60°
Camber Cross Tolerance 0.00° ± 0.60°
Caster ------
Caster Cross Tolerance ------
Total Toe 0.00° ± 0.20°
Steering Wheel Angle ------
Thrust Angle 0.00° ± 0.15°
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
