2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE

Transmission Position Sensor/Switch: Adjustments

PNP Switch Adjustment
^ Tools Required
- J 41545 Park/Neutral Switch Alignment Tool
If a new PNP switch has been rotated and the pin is broken or if using an old PNP switch, adjust the PNP switch.

Adjustment Procedure

Factory service manual diagram




1. Place the shift shaft in the Neutral position.
2. Use the J 41545 to align the slots of the PNP switch to the Neutral position.
3. Align the flats of the shift shaft to the flats in the PNP switch.
4. Install the PNP switch to the mounting boss.

Important: If the PNP switch bolt holes do not align with the mounting boss on the transaxle, verify that the shaft is in the Neutral position.

5. Assemble the PNP switch mounting bolts loosely.

Factory service manual diagram




6. Install the J 41545 on locations (1) and (2) in order to align the PNP switch.

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the PNP switch mounting bolts.
^ Tighten the PNP switch mounting bolts to 25 Nm (18 ft. lbs.).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.