2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor: Service and Repair

REMOVAL PROCEDURE

Factory service manual diagram



1. Turn OFF the ignition.
2. Remove the air intake duct.

Factory service manual diagram



3. Disconnect the evaporative emission (EVAP) purge line.
4. Disconnect the fuel lines.
5. Disconnect the throttle position (TP) sensor electrical connector.

Factory service manual diagram



6. Remove the 2 TP sensor fasteners.

Factory service manual diagram



7. Remove the TP sensor and O-ring.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the TP sensor O-ring on the TP sensor.

Factory service manual diagram



2. Install the TP sensor on the throttle body assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

Factory service manual diagram



3. Install the 2 TP sensor fasteners, using a thread-locking compound on the screws. Loctite� 262, GM P/N #1052624, or equivalent should be used.

Tighten
Tighten the TP sensor attaching screws to 2.0 N.m (18 lb in).

Factory service manual diagram



4. Connect the TP sensor electrical connector.
5. Connect the EVAP purge line.
6. Connect the fuel lines.

Factory service manual diagram



7. Install the air intake duct.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.