Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Diagnosis
The PCM calculates an average voltage the KS signal and takes instantaneous signal voltage readings. The PCM uses the instantaneous signal voltage reading to determine the state of the KS circuitry. If the KS system is operating normally, the PCM should monitor instantaneous KS signal voltage readings varying outside a voltage range above and below the calculated average voltage. The following Diagnostic Trouble Codes (DTCs) are used to diagnose the KS system:
^ If the PCM malfunctions in a manner which will not allow proper diagnosis of the KS circuits, DTC P0325 will set.
^ DTC P0327 is designed to diagnose the KS, and related wiring, so problems encountered with the KS system should set a DTC. However, if no DTC was set but the KS system is suspect because detonation was the customer's complaint, use the tables for DTC P0327 to diagnose the Detonation/Spark Knock Symptom.
^ If the PCM malfunctions in a manner which will not allow proper diagnosis of the KS circuits, DTC P0325 will set.
^ DTC P0327 is designed to diagnose the KS, and related wiring, so problems encountered with the KS system should set a DTC. However, if no DTC was set but the KS system is suspect because detonation was the customer's complaint, use the tables for DTC P0327 to diagnose the Detonation/Spark Knock Symptom.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
