2002 Pontiac Aztek V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE

Air Flow Meter/Sensor: Service and Repair

MASS AIR FLOW (MAF) SENSOR REPLACEMENT

REMOVAL PROCEDURE

Factory service manual diagram



1. Turn OFF the ignition.
2. Disconnect the intake air temperature (IAT) sensor electrical connector.
3. Disconnect the mass air flow (MAF) sensor (1) electrical connector.
4. Remove the air inlet duct from the MAF sensor and the throttle body.
5. Remove the MAF sensor from the air filter housing.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the MAF sensor to the air filter housing.
2. Install the air inlet duct to the MAF sensor and the throttle body.
3. Connect the IAT sensor electrical connector.
4. Connect the MAF sensor (1) electrical connector.
5. Start and idle the engine.
6. Inspect the air intake duct for leaks.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.