Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek FWDFACTORY OEM SERVICE PROCEDURE
Floor Shift Control: Removal
- Remove the console trim plate. See FLOOR CONSOLE TRIM PLATE . Use a flat-bladed tool in order to remove the shift cable end from the shift control lever.
- Remove the shift control cable from the shift control. See Figure. Remove the shift control wire harness from the shift control. Remove the shift control fasteners and the shift control. See Figure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.