Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek FWDFACTORY OEM SERVICE PROCEDURE
Removal Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the strut assembly in the J 45400
using the following procedure. See Special Tools .
- Adjust the lower legs of the J 45400 to the lowest possible coil of the spring. See Special Tools .
- Adjust the upper legs of the J 45400 to the highest possible coil of the spring. See Special Tools .
- Inspect the strut assembly to insure hooks on the strut compress legs are properly installed on the spring coils.
- Verify the strut assembly is parallel with the J 45400 . See Special Tools .
- Compress the spring enough to unload the upper strut mount.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
