2002 Pontiac Aztek FWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper fender brace bolts.
  2. Remove the upper fender brace.
    Fig 1: Removing Upper Fender Brace
    G01577581Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the cruise control module electrical connector.
    Fig 2: Disconnecting Cruise Control Module Electrical Connector
    G01577582Courtesy of GENERAL MOTORS CORP.
  4. Remove the cruise control module nuts.
  5. Disconnect the cruise control cable from the module. Refer to Cruise Control Cable Replacement (4.3L Engine)   . 
  6. Remove the cruise control module.
    Fig 3: Removing Cruise Control Module
    G01577583Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.