Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE
Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the starter/generator control module (SGCM) cooling system. Refer to Draining and Filling Cooling System - Starter/Generator Control ModuleΒ .
- Raise the hood to the service position, and perform the following steps:
- Remove the ground strap from the hood.
- Remove the hood hinge bolts (1).
- Raise the hood until vertical.
- Install the hood hinge bolts until snug in the service position (2).
- Reposition the SGCM coolant tank hose clamp (2) from the SGCM coolant tank (3).
- Remove the SGCM coolant tank hose (1) from the SGCM coolant tank (3).
- Reposition the SGCM pressure relief hose clamp from the SGCM pressure relief valve.
- Remove the SGCM pressure relief hose from the SGCM pressure relief valve.
- Remove the surge tank mounting bolts. Position the surge tank away from the SGCM module.
- Remove the bolts (1) from the brace.
- Reposition the SGCM coolant pump inlet hose clamp (1) from the SGCM coolant tank (2).
- Remove the SGCM coolant pump inlet hose (3) from the SGCM coolant tank (2).
- Remove the bolts from the SGCM coolant tank.
- Reposition the SGCM coolant tank in order to access the SGCM rear bolt.
- Remove the rear bolt (2) from the SGCM.
- Remove the front bolt (3) from the SGCM.
- Reposition the SGCM in order to remove the SGCM coolant tank.
- Remove the SGCM coolant tank (2) from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
