Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
8-Digit GM Part Number: The scan tool displays an 8 digit number which indicates the GM part number of the module.
# of Fobs Programmed: The scan tool displays 1 Fob - 4 Fobs to indicate the number of keyless entry transmitters that are programmed for the system.
Calibration ID: The scan tool displays a 4 digit number which indicates the calibration ID number of the module.
Invalid Transmitter: The scan tool displays More Than 10 or Less Than 10 which indicates how many times an invalid transmitter has been used in the vicinity of the vehicle.
Key Fob 1 Low Voltage: The scan tool displays counts which indicates the number of times a low battery voltage level was received.
Key Fob 1 Battery Status: The scan tool displays OK to indicate a good battery voltage level was last received.
Key Fob 2 Low Voltage: The scan tool displays counts which indicates the number of times a low battery voltage level was received.
Key Fob 2 Battery Status: The scan tool displays OK to indicate a good battery voltage level was last received.
Key Fob 3 Low Voltage: The scan tool displays counts which indicates the number of times a low battery voltage level was received.
Key Fob 3 Battery Status: The scan tool displays OK to indicate a good battery voltage level was last received.
Key Fob 4 Low Voltage: The scan tool displays counts which indicates the number of times a low battery voltage level was received.
Key Fob 4 Battery Status: The scan tool displays OK to indicate a good battery voltage level was last received.
Key Pressed on Fob: The scan tool displays Dr. Door Unlock, Door Lock, All Door Unlock, Trunk, or Fuel Door/Alarm which indicates which keyless entry transmitter button was last pressed.
Last Fob Used: The scan tool displays Fob#1- Fob#4 which indicates the number of the last keyless entry transmitter used.
PROM ID: The scan tool displays a 4 digit number which indicates the ID number of the PROM associated with the module.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.