2002 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE

Conditions For Running DTC

  • No MAP sensor DTC P0107, P0108, P1106 or P1107.
  • No TP sensor DTC P0121, P0122, P0123, P1121 or P1122.
  • No AT ISS DTC P0716 or P0717.
  • No TFP manual valve position switch DTC P1810.
  • The TP angle is greater than 12 percent.
  • The engine torque is 40-300 ft. lbs. (55-400 N.m).
  • The transmission is not in Park or Neutral.
  • The input shaft speed is 1500 RPM or greater.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.