Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE
Diagnostic Aids
- Crankshaft Position (CKP) signal is not needed to start and run.
- Many situations may lead to an intermittent condition. Perform each inspection or test as directed.
- Inspect PCM and engine grounds for clean and secure connections.
- For intermittent conditions, see INTERMITTENTS in TROUBLE SHOOTING - NO CODES - TRUCKS article.
NOTE:
Remove any debris from connector surfaces before servicing a component. Ensure gaskets are installed correctly. Gaskets prevent contaminate intrusion.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
