2002 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. Perform Diagnostic System Check - Engine Controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 6.6L SIERRA & SILVERADO article. After performing Diagnostic System Check - Engine Controls, go to next step.
  2. Start and idle engine. Observe message center in instrument cluster. Does message center indicate water-in-fuel? If yes, go to next step. If no, go to INTERMITTENTS in TROUBLE SHOOTING - NO CODES - TRUCKS article.
  3. Perform Water-In-Fuel Draining Procedure. See WATER-IN-FUEL DRAINING PROCEDURE (6.6L) . After performing procedure, go to next step.
  4. Start and idle engine. Observe message center in instrument cluster. Does message center indicate water-in-fuel? If yes, go to next step. If no, go to step  10.
  5. Disconnect water-in-fuel sensor. Does scan tool display Water-In-Fuel parameter is OFF? If yes, go to step  8. If no, go to next step.
  6. Turn OFF the ignition. Disconnect ECM. Probe Water-In-Fuel Indicator Control circuit with a test light connected to battery voltage. Does test light illuminate? If yes, go to next step. If no, go to step  9.
  7. Repair short to ground in Water-In-Fuel Indicator Control circuit. After repairs, go to step  10.
  8. Replace water-in-fuel sensor. After repairs, go to step  10.
  9. Replace ECM. Perform ECM relearn procedures. See PROGRAMMING in SELF-DIAGNOSTICS - 6.6L SIERRA & SILVERADO article. After repairs, go to next step.
  10. Operate system in order to verify repair. Did you correct the condition? If yes, system is okay. If no, go to step  3.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.