2002 Pontiac Aztek AWDFACTORY OEM SERVICE PROCEDURE

Injector Balance Test

An injector balance test is performed with scan tool. This test will properly identify a stuck closed or noisy injector nozzle. Typically, a nozzle failure will fall into this criteria.

  1. Install scan tool.
  2. Start and idle engine.
  3. Perform injector balance test on each cylinder. If a suspect nozzle has been located, nozzle can be swapped with adjacent cylinder and balance test can be repeated as a check to positively identify a malfunctioning nozzle.
  4. Locate and replace malfunctioning nozzle and glow plug.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.