2001 Pontiac Firebird Formula, AutomaticFACTORY OEM SERVICE PROCEDURE

Diagnostic Aids

AIR pump generally operates upon initial start-up before engine goes into closed loop fuel control. Some systems perform a passive diagnostic test at this time. See CONDITIONS FOR RUNNINGΒ . Active diagnostic test is performed after the engine goes into closed loop.

On vehicles that perform a passive test, the active test will only run if passive test fails or is indeterminate. If diagnostic test does not run, observe fuel trim correction. If fuel trim correction is more than +/- 4 percent, AIR system test may not run. If status does not update, test can be repeated until I/M system status updates to YES. See DIAGNOSTIC PROCEDURESΒ .

I/M System Status does not indicate whether test has passed or failed, only that a decision was made. When all diagnostics for a specific system have run and passed, I/M system status will update to YES. If test for a specific system has failed, I/M system status will update to YES, indicating a determination was made, even if all required tests have not run. When a failure occurs, emission related DTC portion of I/M system status display will indicate Malfunction Indicator Light (MIL) is requested.

I/M system status also registers the number of DTCs. First failure of a type "B" DTC does not constitute a final determination of pass or fail, and will not update I/M system status to YES. A second trip is required, and all conditions to run must be met for test to run again. These conditions may include a partial to complete engine cool down.

I/M system status will update only when an emission related DTC fails for a second time, or when all tests pass. If an impending failure exists, system may require more time to run diagnostic than in set procedure. If test does not run after numerous attempts and no DTCs are set, review scan tool data list and service information for an indication of why test does not complete. See INSPECTION/MAINTENANCE SYSTEM CHECKΒ .

Some tests may abort due to changes in conditions while test is running. Example: changes in engine load, such as cooling fan or A/C compressor clutch turning ON, may cause test to abort. If a diagnostic test is difficult to run, observe I/M system status display while maintaining necessary enable conditions until system status updates to YES.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.