Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Pontiac Aztek Base, FWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Aztek and 2002 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the cruise control module to the mounting bracket.
NOTE: Refer to FASTENER NOTICE .
Install the mounting bracket bolt to the cruise control module.
Tighten

Tighten the bolt to 6 N.m (53 lb in).

Fig 1: Installing Cruise Control Module, Mounting Bracket and Bolts
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector to the module.
Install the cruise control cable to the module. Refer to Cruise Control Cable Replacement .
Adjust the cruise control cable. Refer to Cruise Control Cable Replacement .

Fig 2: Connecting Cruise Control Module Electrical Connector
Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: Cruise Control Module Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.