Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Pontiac Aztek Base, FWDFACTORY OEM SERVICE PROCEDURE

Component Locations

NOTE: For component locations, refer to illustrations. See Fig 1 and Fig 2 .

COMPONENT LOCATIONS

Component	Location
Body Control Module	Behind Right Center Console Access Panel, Inside Of Console, Attached To Center Console Fuse Block
Center Console Fuse Block	Behind Right Console Access Panel, Inside Of Console
Master Window Switch	On Drivers Door Panel
Underhood Fuse Block	In Front Of Right Wheelwell, Above Battery
Window Motor	Behind Door Panel In Appropriate Door

Fig 1: Identifying Center Console Fuse Block Components

Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: Power Window System

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.