Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Pontiac Aztek Base, FWDFACTORY OEM SERVICE PROCEDURE
Programming Verification
- Using scan tool, clear DTCs.
- Start engine.
- If engine does not start, or engine operates poorly, repeat service programming procedure function from scan tool. Perform following procedures before programming PCM:
- Ensure PCM and DLC connections are okay.
- Ensure Techline operating software is up to date.
- Ensure calibration part number is correct for vehicle.
- Program the PCM. If PCM still cannot be programmed properly, replace the PCM. See POWERTRAIN CONTROL MODULE under REMOVAL & INSTALLATION. Replacement PCM must be programed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.