2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
A/C SYSTEM TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
A/C Compressor Mounting Bolts 13-20 (18-27)
INCH Lbs. (N.m)Β 
A/C Line-To-Condenser Core 61-87 (7-10)
A/C Manifold & Tube-To-Evaporator Bolt 61-88 (7-10)
Clutch Hub Bolt 108 (12)
Condenser Core Mounting Bolt 71-106 (7-12)
Expansion Valve Bolt 31-48 (4-5)
High/Low Hose-To-Compressor Bolt 61-88 (7-10)
Receiver Drier Bolt 61-88 (7-10)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.