2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Refrigerant Pressure Switch Removal/Installation: Notes

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Discharge the refrigerant from the system. See REFRIGERANT RECOVERYΒ . See REFRIGERANT CHARGINGΒ .
  3. Loosen the refrigerant pressure switch using two spanners.
  4. Remove in the order indicated in the figure.
    Fig 1: Refrigerant Pressure Switch Removing Sequence
    G00975605Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
    Fig 2: Refrigerant Pressure Switch With Torque Specifications
    G00975606Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.