2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Section 713 (Engine Cooling System): Specifications

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Condenser Inlet Fitting 25 N.m 18 lb ft
Condenser Outlet to Evaporator Line Bolt 25 N.m 18 lb ft
Condenser to Radiator Bolt 5 N.m 44 lb in
Fan Bolt 10 N.m 89 lb in
Lower Radiator Mounting Panel Bolt 10 N.m 89 lb in
Surge Tank Bolt 10 N.m 89 lb in
Surge Tank Line Fitting 21 N.m 15 lb ft
Thermostat Bypass Pipe-to-Front Cover Bolt 11 N.m 98 lb in
Thermostat Bypass Pipe-to-Throttle Body Nut 25 N.m 18 lb ft
Thermostat Housing Bolt 25 N.m 18 lb ft
Transaxle Oil Cooler Line Fitting 30 N.m 22 lb ft
Water Pump Bolt 10 N.m 89 lb in
Water Pump Pulley Bolt 25 N.m 18 lb ft
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.